Exporting Sensor Data To A Peripheral System - Simrad ES80 Reference Manual

Simrad ES80 Reference Manual

Exporting sensor data to a peripheral system

The information provided to the ES80 from various sensors can also be useful for
other systems on board. The ES80 allows you to export the same sensor data that was
originally imported. This can "reuse" the same information on other systems. The
page is used to set up and control this export functionality.
Output
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
Context
The information imported to the ES80 from various sensors can also be useful for
other systems on board your vessel. The ES80 allows you to "re-export" this sensor
information. When activated, the selected sensor information is sent out on the chosen
communication port (serial or LAN) on the Processor Unit.
The following sensor data can be exported:
• Navigation
• Motion sensor
Procedure
1 Connect the peripheral system to an available communication port on your
Processor Unit.
This is described in the ES80 Installation manual.
2 Open the
Setup
3 Select .
Output
Observe that the
pages selected by the menu on the left side.
4 On the left side of the
Observe that the
5 Observe that the available serial and network interface ports on the Processor Unit
are listed.
6 Set up the relevant serial or Ethernet (LAN) communication parameters.
a On the
I/O Setup
180
menu.
dialog box opens. This dialog box contains a number of
Output
dialog box, select
Outputs
page opens.
I/O Setup
page, select the port you wish to set up.
.
I/O Setup
Relay
406273/C