Simrad ES80 Reference Manual page 400

Simrad ES80 Reference Manual
Details
Installed Outputs
The
Installed Outputs
currently selected outputs. To remove or
edit an output type, select it in the
box.
Outputs
• Select
Remove
• Select to change the settings.
Edit
• Select to add a new output.
New
Output
Select which datagram format to export.
Only one output type is available, and the
exported data is then customized to meet
the Olex requirements.
Output Destination
You can export the data on a communication port (serial or LAN) on the Processor
Unit.
• : Select
Port
your Processor Unit. Select which serial or LAN port to use for the output data.
•
Inspect Port
select
Inspect Port
setup dialog box opens. You are not permitted to make any changes.
You can not define the communication port parameters here. If you need to
adjust these, you must select
parameters. The
boxes.
• : Select
Monitor
dialog box allows you to study the communication stream on the chosen serial
line or LAN port.
Add
Select to start export of the chosen data format. Once an output type has been
Add
defined, it is listed in the
Remove
Once an output type has been defined, it is listed in the
the left side of the page. To remove the output, select the relevant format in the
Installed Outputs
398
box lists all the
Installed
to delete the output.
if you wish to send the information to a communication port on
Port
: Once you have selected a serial or Ethernet communication port,
to inspect the current port parameters. The relevant port
I/O Setup
page is located in the
I/O Setup
to open the
Monitor
Installed Outputs
box, and then select
after you have defined the data output
Installation
dialog box. The
Port Monitor
box on the left side of the page.
Installed Outputs
.
Remove
and dialog
Output
Port Monitor
box on
406273/C