Simrad ES80 Reference Manual
Note
This procedure is only valid if your ES80 shall operate with a Wide Band Transceiver
(WBT).
Once you receive your software license string(s), do not lose them. We suggest that you
copy the information into a text file (for example Notepad), and add relevant information.
Place the text file on the Processor Unit desktop, and make sure that backup copies
are made.
Procedure
1
Obtain the necessary information about your transceiver(s) and transducer(s).
Write down:
a
The serial number for each transceiver.
b
Which transducers you have connected to each transceiver.
c
The center frequency for each transducer.
d
The Q-value for each transducer.
e
The maximum nominal power rating for each transducer.
2
Send the necessary information to one of Simrad's dealers or distributors.
You can also use the request form on http://www.simrad.com/support, or contact
our support department directly.
You can use the following e-mail address:
•
purchase.order@simrad.com
Once the software license string(s) have been returned to you (most likely by e-mail),
you can install the licenses into the software.
3
Open the
Setup
4
On the
menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
5
On the left side of the
Observe that the
6
Select
Type License String
If you do not have a computer keyboard connected to your ES80 system, select the
button to open an on-screen keyboard. If you have received the license
Keyboard
string on an electronic format (e-mail or text file), you can copy the string from the
source document and paste it into the
7
Select
to save the license string and close the
OK
66
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page opens.
Software License
, and type the license string into the dialog box.
.
Software License
dialog box.
Type License String
Type License String
.
dialog box.
406273/C