Simrad ES80 Reference Manual page 179

3 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
4 On the left side of the
5 Select the motion reference format you want to use.
6 Select the port you wish to use (serial or LAN).
7 If you want to check the communication parameters, select
Note
You cannot make any changes here. To change the communication parameters, use
the page. The
I/O Setup
dialog boxes.
8 If you want to check that the peripheral system is transmitting data to the ES80,
select .
Monitor
The
Port Monitor
), and one for outgoing messages (
Data
knowledge of the data communication to investigate the datagrams. The
dialog box is a tool for debugging purposes. It is neither required nor
Monitor
intended for normal operation of the ES80.
9 Type a custom name to identify the interface in other dialog boxes.
10 Select which datagram(s) you want to import from the sensor.
11 If relevant, specify a dedicated talker ID.
12 Provide the accurate physical location of the sensor (or its antenna) with reference
to the vessel's coordinate system.
The position of certain sensors must be defined as an offset to the Ship Origin in the
coordinate system to maximize performance. These offset values are all required
to allow the ES80 to give you as accurate information as possible. The degree of
accuracy offered by the ES80 is directly related to the accuracy of the information
you enter on the
a Select the offset value on the X axis (fore-and-aft direction) from the Ship
Origin. Adjust with a positive value for X if the sensor is located ahead of the
ship origin.
Select the offset value on the Y axis (athwartship) from the Ship Origin.
b
Adjust with a positive value for Y if the sensor is located on the starboard
side of the ship origin.
c Select the offset value on the Z axis (vertical) from the Ship Origin. Adjust
with a positive value for Z if the sensor is located under the ship origin.
406273/C
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
page is located in the
I/O Setup
dialog box provides one text box for incoming messages (
page.
Sensor Installation
.
Sensor Installation
Installation
). Use these boxes and your
Tx Data
Operating procedures
.
.
Inspect Port
and
Output
Rx
Port
177