Simrad ES80 Reference Manual page 186

Simrad ES80 Reference Manual
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Procedure
1 Connect the synchronization cable from the remote system to an available
communication port on your Processor Unit.
This is described in the ES80 Installation manual.
2 Turn on the ES80, and set it to normal use.
3 Open the
Setup
4 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
5 On the left side of the
6 Select
Synchronization Mode
•
Stand-alone
Synchronization is turned off.This synchronization mode is used if the
ES80 is working by itself and with no synchronization required. This is the
default setting. The ES80 operates using its internal ping interval parameters,
independent of any trigger signals arriving at the synchronization port.
This mode is unavailable if you set
Port.
The
Synchronization Delay
switched off.
•
Master
Master mode is used if the ES80 is going to act as the controlling unit in a
synchronized system. The peripheral hydroacoustic system(s) are only permitted
to transmit when enabled by the ES80. When Master mode is selected, the ES80
will run using its internal ping interval parameters and send trigger signals to the
peripheral system(s).
This mode is unavailable if you set
Port.
•
Slave
Slave mode is used if the ES80 is going to transmit only when permitted by a
peripheral system. When Slave mode is selected, the ES80 does not transmit
("ping") unless an external trigger appears on the chosen synchronization port.
The peripheral system may be any other hydroacoustic product (for example an
echo sounder or sonar), or even a dedicated synchronization system.
184
dialog box, you must always select
Installation
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
dialog box, select
Installation
.
setting is not applicable when synchronization is
.
Synchronization
Synchronization Port
Synchronization Port
to save the
Apply
.
to Transceiver Auxiliary
to Transceiver Auxiliary
406273/C