Locating The Position Of Single Fish In The Beam - Simrad ES80 Reference Manual

Selecting
Setup
dialog box. The
Options
the operational parameters used to present the data in the information panes.
7 Select in the top right corner to close the information pane.
Close

Locating the position of single fish in the beam

The Echo Position information pane can be useful during fishing. It shows you both the
horizontal and vertical position of single fish in the beam.
Context
The Echo Position information pane shows the
position of the detected single echoes within the
beam. The current ping (largest circles) and the
three previous ping (smaller circles) are shown.
The view is "from the side". The colours indicate
the echo strength.
Each circle in the information pane identifies
a single fish. You can observe how these move
through the ES80 beam. The height of the cone
changes to reflect the current depth.
Procedure
1 Click in the echogram view you wish to
investigate.
This will make the view "active". The
"active" echogram view is identified with
a thicker border.
2 On the top bar, select the appropriate button
to open the information pane.
3 Click the bottom right corner of the information pane, and drag to
requested size.
4 Select a
Transparency
The chosen transparency percentage is used on all open information panes.
406273/C
in the Fish Position information pane opens the
Information Pane Options
setting that fits your requirements.
Operating procedures
Information Pane
dialog box allows you to change
137