Simrad ES80 Reference Manual page 375

•
Baud Rate
This is the current baud rate specified for the serial line. The communication
parameters defined for
–
Baud Rate
–
Data Bits
– : None
Parity
–
Stop Bits
Some instruments may offer other parameters and/or options. You must always
check the relevant documentation provided by the manufacturer.
•
Protocol
This is the current protocol specified for the port. Each port can receive
multiple datagrams simultaneously, provided that they all use the same protocol.
However, only one peripheral device can be physically connected to the port. If
you want to connect several peripheral devices to a single serial port, you must
route them through a "mixer". This can be a hardware unit or a computer (with
relevant software) collecting and streaming the datagrams.
•
Input
This column identifies the external sensor (any type of "measuring device") that
is currently connected to the port. To choose what type of device to import
data from, select
LAN Ports
This table shows the available Ethernet (LAN) ports on the Processor Unit. Each
Ethernet adapter on your Processor Unit supports any number of network ports. To
add a new port, select
Ports that have not been initiated correctly have a red background colour.
•
Name
This is the given identity of the network (LAN) port. By default, the ports
are numbered.
•
Remote IP Address
This is the Internet Protocol (IP) address for a peripheral device. If the data
communication between your Processor Unit and the peripheral device is set up
to only import data from the device, the remote IP address is not required. If you
want to export information from the Processor Unit to one or more peripheral
devices (broadcast), set
default setting. If you use point-to-point communication in a closed network,
you need to set the remote IP address manually.
406273/C
NMEA 0183
: 4800 b/s
: 8
: 1
under the table.
Input
under the table.
Add
Remote IP Address
Functions and dialog boxes
are:
to 255.255.255.255. This is the
373