Simrad ES80 Reference Manual page 358

Simrad ES80 Reference Manual
Serial number
This is the serial number of the transceiver. This number is fixed and cannot be
changed.
Tip
This information is also found in the
You open the
BITE
Channel number
Each transceiver may have one or more transducers connected. This digit identifies
each of these transceiver/transducer channels. You can not change this information.
If you use split-beam transducers, you will only have one transducer on each
transceiver. The channel number will then always be one -1-.
Transducer name
This column identifies the transducer that is connected to the transceiver. The
name shown is the
ES80 configuration using the
When you set up the ES80 for use, select the transducer from the list.
Note
You can only select from the transducers that you have previously installed on the
Transducer Installation
Transducer model
The transducer model is identified. In most cases, this is the actual product name
of the transducer. You are not able to change this information.
Status
The current status of the channel is shown.
• : The channel is already in use, probably by another echo sounder on the
Busy
same network. You cannot connect to this channel.
• : This channel is connected to your ES80 system.
Installed
• : This channel cannot be used.
Lost
• : This channel is vacant and ready for use.
Available
Mux
In this context "Mux" means Multiplexer.
Certain transceivers for the ES80 support multiplexed outputs. When applicable, a
tick box appears in the channel list to enable the multiplexing functionality.
Select the tick box to expand the channel listing to include the additional channels,
transducer names and transducer models.
356
BITE
dialog box from the
you defined when you added the transducer to the
Custom name
Transducer Installation
page.
(Built-In Test Equipment) dialog box.
menu.
Setup
page.
406273/C