Simrad ES80 Reference Manual page 194

Simrad ES80 Reference Manual
of the transceiver(s) you use. Each software license code "unlocks" one Wide Band
Transceiver (WBT) for operational use with a set of predefined properties.
The software license is not linked to the physical Processor Unit. You can therefore
easily move the software from one computer to another, just remember to make a copy
of the license string.
In order to obtain a software license you must contact a Simrad dealer or distributor. You
can also use the request form on http://www.simrad.com/support, or contact our support
department directly.
Note
This procedure is only valid if your ES80 shall operate with a Wide Band Transceiver
(WBT).
Once you receive your software license string(s), do not lose them. We suggest that you
copy the information into a text file (for example Notepad), and add relevant information.
Place the text file on the Processor Unit desktop, and make sure that backup copies
are made.
Procedure
1 Obtain the necessary information about your transceiver(s) and transducer(s).
Write down:
a The serial number for each transceiver.
b Which transducers you have connected to each transceiver.
c The center frequency for each transducer.
d The Q-value for each transducer.
e The maximum nominal power rating for each transducer.
2 Send the necessary information to one of Simrad's dealers or distributors.
You can also use the request form on http://www.simrad.com/support, or contact
our support department directly.
You can use the following e-mail address:
• purchase.order@simrad.com
Once the software license string(s) have been returned to you (most likely by e-mail),
you can install the licenses into the software.
3 Open the
Setup
4 On the menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
192
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
.
406273/C