Simrad ES80 Reference Manual page 406

Simrad ES80 Reference Manual
Related dialog boxes
About dialog box, page 412
BITE: Sensors page
The page presents a table with all the sensors currently connected to the ES80.
Sensors
For each sensor, the status is provided.
How to open
This page is located in the
menu.
Setup
Description
For the ES80 to use and offer correct navigational information, one or more external
sensors must be connected. Typical sensors are those that provide speed, heading and
geographical position. A motion sensor (motion reference unit) can also be connected.
Each sensor that is connected to the ES80 for input or output purposes is listed. All
relevant status information is provided.
Tip
On the
Sensor Installation
information from. The
The dialog box is located on the
Installation
The
Sensor Configuration
the information from the "most reliable" sensor is used by the ES80. You can also
define manual values in case a sensor is unserviceable, or not installed. The
page is located in the
Configuration
The settings allow you to control the properties of each of the available
I/O Setup
communication ports. The
dialog boxes.
Return to...
BITE (Built-In Test Equipment) dialog box, page 400
404
dialog box. You open the
BITE
page you define which external sensors your ES80 will import
page is located in the
Sensor Installation
page allows you to define a datagram priority, so that
Installation
page is located in the
I/O Setup
BITE
Installation
menu.
Setup
dialog box.
Installation
dialog box from the
dialog box.
Sensor
and
Output
406273/C