Setting Up Depth Output To An External System - Simrad ES80 Reference Manual

Simrad ES80 Reference Manual
13 Select to save the new sensor interface you have defined.
Add
The sensor interface is added to the
page.
14 Select and then
Apply
dialog box.

Setting up depth output to an external system

The ES80 can export depth information on a dedicated communication port (serial or
Ethernet) The
Depth Output
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
Context
The ES80 can export the depth information on several NMEA datagram formats. You can
export several depth formats simultaneously, as each of them is handled independently.
Procedure
1 Connect the peripheral system to an available communication port on your
Processor Unit.
This is described in the ES80 Installation manual.
2 Open the
Setup
3 Select .
Output
Observe that the
pages selected by the menu on the left side.
4 On the left side of the
Observe that the
5 Observe that the available serial and network interface ports on the Processor Unit
are listed.
6 Set up the relevant serial or Ethernet (LAN) communication parameters.
a On the
I/O Setup
178
Installed Sensors
to save all the parameters and close the
Close
page is used to set up the output parameters.
menu.
dialog box opens. This dialog box contains a number of
Output
dialog box, select
Outputs
page opens.
I/O Setup
page, select the port you wish to set up.
list on the
Sensor Installation
Installation
.
I/O Setup
406273/C