Starting Normal Operation; Turning On The Es80 - Simrad ES80 Reference Manual

Simrad ES80 Reference Manual

Starting normal operation

Topics
Turning on the ES80, page 30
Getting to know the user interface, page 31
Checking transceiver and transducer settings, page 33
Selecting Normal mode to start "pinging", page 35
Verifying that the bottom is correctly detected, page 36
Checking and/or editing the transceiver parameters, page 37
Turning off the ES80, page 38

Turning on the ES80

In order to use the ES80, you must first turn it on. You must first turn on the display,
the Processor Unit, the transceiver(s), and the Ethernet switch (if applicable). After this
you can start the ES80 program.
Prerequisites
The ES80 is installed as specified in the ES80 Installation manual. Minimum one Wide
Band Transceiver (WBT) with one or more transducers has been connected. All relevant
navigation sensors are operational.
Caution
You must never start ES80 transmissions ("pinging") when the ship is in dry dock. The
transducer may be damaged if it transmits in open air.
Procedure
1 Make sure that each transceiver is turned on.
2 Turn on the display and the Processor Unit, and start the ES80 program.
3 Once the ES80 program has started, observe that the presentation fills the entire
screen.
4 On the menu in the top right corner of the presentation, select
Main
and then choose the default settings.
5 At the bottom of the
It is flashing to indicate that even if the ES80 is turned on, "pinging" is disabled.
The ES80 is in Normal mode, but
This is for safety reasons.
30
menu, observe that the
Main
TX Power
menu icon is flashing.
Operation
is set to Off to prevent transmission.
,
User Settings
406273/C