Turning On The Es80 To Passive Mode - Simrad ES80 Reference Manual

Simrad ES80 Reference Manual
f Click once on your network adapter to select it, then right-click and select
on the shortcut menu.
Properties
g On the list of connections, select
.
Properties
3 Select
Use the following IP address
• : 157.237.15.12 (Recommended)
IP Address
• : 255.255.255.0
Subnet mask
You can leave
Subnet mask
saying that the message subnet mask is missing, select
mask is then automatically generated.
4 Select to save the selected settings, and then close all the dialog boxes.
OK
Further requirements
If you later need to change the IP address, always restart the transceiver before you
start the ES80.

Turning on the ES80 to Passive mode

In order to use the ES80, you must first turn it on. In this situation we do not want the
ES80 to transmit, so we will leave it in Passive mode.
Prerequisites
This procedure assumes that the entire ES80 installation has been inspected. All power
sources have been measured and verified. All system cables and connectors have been
checked and tested. The ES80 has been installed on the Processor Unit.
Context
The program is not automatically started when the Processor Unit is turned on. Once the
operating system has started, select the ES80 program icon on the desktop.
When the ES80 is powered up and set to Normal mode, it will use the transducer to
transmit acoustic pulses into the water.
Caution
You must never start ES80 transmissions ("pinging") when the ship is in dry dock. The
transducer may be damaged if it transmits in open air.
Procedure
1 Make sure that the Wide Band Transceiver (WBT) is turned on.
The Wide Band Transceiver (WBT) power supply is fitted with an on/off switch.
64
Internet Protocol 4 (TCP/IPv4)
, and type the IP address and network mask.
blank and select . When you see an error message
OK
, and then
again. A default subnet
OK
406273/C