Table of Contents
Advertisement
Procedure
1
Open the
Setup
2
On the
menu, select
Setup
Observe that the
of pages selected from the menu on the left side.
3
Set up the interfaces to the navigation sensors.
a
On the left side of the
b
Set up the relevant serial or Ethernet (LAN) communication parameters.
c
At the bottom of the page, select
d
On the left side of the
e
Select the type of sensor you want to interface, and define the relevant
parameters.
f
Select
Add
g
On the left side of the
h
Define the priority of the datagrams, and set up relevant configuration
parameters.
i
At the bottom of the page, select
4
Repeat for each sensor interface that you need to set up.
5
Continue your work in the
Related topics
Setting up the interfaces to peripheral devices, page 132
Defining the serial and Ethernet (LAN) port parameters
For any sensor interface to work, the communication parameters must be set up correctly.
The SN90 software automatically scans the Processor Unit to locate and identify
the available communication ports. Once the software has established a list of valid
interfaces, you can set up and control the communication parameters.
Prerequisites
This procedure assumes that:
• You have a vacant interface port on your Processor Unit.
• You are familiar with NMEA and other relevant datagram formats.
• You know how to set up the parameters for serial and local area network (LAN)
communication.
381295/B
menu.
Installation
dialog box opens. This dialog box contains a number
Installation
Installation
Installation
to save the new sensor interface you have defined.
Installation
Installation
.
dialog box, select
I/O Setup
to save your settings.
Apply
dialog box, select
Sensor Installation
dialog box, select
Sensor Configuration
to save your settings.
Apply
dialog box, or select
Operating procedures
.
.
.
to close it.
OK
133
Advertisement
Table of Contents
