Simrad ES80 Reference Manual page 370

Simrad ES80 Reference Manual
Remove (sensor)
The
Installed Sensors
ES80. If you want to delete a sensor, select it in the list, and then select
the bottom of the
Note
You cannot undo this operation.
Edit (sensor)
The
Installed Sensors
ES80. If you want to edit the parameters of a previously installed sensor, select it
in the list, and then select
Return to...
Installation dialog box, page 346
Related tasks
Installing navigation sensors and other sensors, page 164
Defining the serial and Ethernet (LAN) port parameters, page 165
Setting up the input from a navigation system (GPS), page 167
Configuring the sensor interface, page 169
Setting up a serial or LAN (Ethernet) port for annotation input, page 171
Connecting a catch monitoring system to a serial or LAN (Ethernet) port, page 172
Connecting a trawl system to a serial or LAN (Ethernet) port, page 174
Setting up the input from a motion reference unit (MRU), page 176
Related dialog boxes
BITE (Built-In Test Equipment) dialog box, page 400
BITE: Sensors page, page 404
Port Monitor dialog box, page 446
Datagram formats
NMEA datagram formats, page 491
Proprietary datagram formats, page 504
Third party datagram formats, page 517
Conceptual descriptions
Vessel coordinate system, page 455
368
list contains all the sensors that are currently installed on the
page.
Sensor Installation
list contains all the sensors that are currently installed on the
at the bottom of the
Edit
page.
Sensor Installation
at
Remove
406273/C