Simrad ES80 Reference Manual page 231

Tip
By default, the vessel speed is shown in knots. You can change the measurement unit on
the page. The
Units
Return to...
Navigational information, page 226
Related dialog boxes
Display Options: General page, page 331
Units page, page 378
Temperature read-out
The navigational information on the top bar may include a read-out of the current
water temperature.
Prerequisites
To see this information on the top bar, you must enable it using the
functions in the
Top Bar
dialog box is located on the
Description
If a suitable sensor is connected to the ES80 Processor Unit, the top bar may show
you the current temperature. The function is offered to allow you to monitor the water
temperature, but it will display any temperature reading that is made by the sensor.
Tip
By default, the temperature is shown in Celcius. You can change the measurement unit
on the page. The
Units
If you define a manual temperature value in the
the read-out. The
Temperature
Return to...
Navigational information, page 226
Related dialog boxes
Display Options: General page, page 331
Environment dialog box, page 340
Units page, page 378
406273/C
page is located in the
Units
Display Options
menu.
Display
page is located in the
Units
Environment
dialog box.
Installation
dialog box. The
Display Options
Installation
Environment
dialog box is located on the
User interface
dialog box.
dialog box, it is shown in
menu.
Setup
229