Simrad ES80 Reference Manual page 372

Simrad ES80 Reference Manual
Tip
The ES80 can communicate with several different sensor types. On the
page you define which external sensors your ES80 will import information from. You
must also decide which datagram formats that will be accepted. Open the
page in the
Installation
A summary of all the sensors that are connected to the ES80 is provided in the
(Built-In Test Equipment) dialog box.
When you save echo data in RAW format, all sensor data are included.
Note
If you have two sensors providing the same information, but on different communication
ports, certain limitations apply. During normal operation, you can easily decide which
sensor you wish to use. During replay, you can only play back from one of these sensors.
For this reason, only the information from the currently "active" sensor is saved.
When you work in the
changes made on a page. You must do this before you continue working on a different
page.
Details
Sensor
All the sensors are listed. Select a sensor in this list to set up the datagram priority
and/or configuration.
Source
All the datagrams that have been selected for input data are shown in this list.
There is one list on each page representing the type of information indicated by the
page name. To change the priority for a given datagram, select it, and change its
location on the list using the arrow buttons.
Auto
Select to control the functionality.
Auto
• With enabled, the priority list is used. Information is imported from the
Auto
sensor at the top of the list. If the sensor fails to provide information for more
than 20 seconds, data from the next sensor is used.
• With disabled, the priority list is not used. Information is imported from
Auto
the sensor at the top of the list. All other sensors are ignored.
Configuration
On most of the pages you can
specify a manual value. Use
this function if a sensor is unserviceable or not installed. Click to enable this
function, and select or type the requested value.
370
dialog box.
Installation
dialog box, you must always select
Installation
Sensor Installation
Sensor
BITE
to save the
Apply
406273/C