Simrad ES80 Reference Manual page 297

•
Installation
Prior to use, the ES80 must be set up to communicate with the relevant peripherals.
This includes the transducer(s). The
peripherals on individual pages, and allows you to set up the basic parameters related
to installation and operation. In most cases, you only need to do this once.
Installation dialog box, page 346
The following pages are provided.
–
Transducer Installation
The transducers you wish to use with the ES80 must be "installed" as a part of
the software configuration. Which transducers to use depends on the number of
transceivers in your system, and the licenses you have for these. Unless you
replace a broken transducer, or add a new, you only need to do this once.
Transducer Installation page, page 348
–
Transceiver
The
Transceiver
Processor Unit to each transceiver. In turn, each transceiver is assigned one or
more transducers. Two pages are used. The
you a list of the available transceivers, and allows you to make the connections to
the Processor Unit, and to the transducers you have installed. The
page allows you to control the Internet Protocol (IP) Addresses used by
Address
the Processor Unit to communicate with the transceivers.
Transceiver pages, page 352
Transceiver Installation page, page 353
Transceiver IP Address page, page 360
–
Sensor Installation
For the ES80 to use and offer correct navigational information, one or more
external sensors must be connected. Typical sensors are those that provide speed,
heading and geographical position. On the
which external sensors your ES80 will import information from. You must also
decide which datagram formats that will be accepted. Once a sensor has been
chosen, you must select the offset values that define the sensor's physical location
relative to your vessel's coordinate system.
Sensor Installation page, page 363
–
Sensor Configuration
With several sensors connected to the ES80, many of them will provide the same
datagrams. We cannot expect that the datagrams provide the same information.
The
Sensor Configuration
the information from the "most reliable" sensor is used by the ES80. You can also
define manual values in case a sensor is unserviceable, or not installed.
Sensor Configuration page, page 369
406273/C
Installation
pages are used to define the settings necessary to connect the
page allows you to define a datagram priority, so that
dialog box collects all relevant
Transceiver Installation
page you define
Sensor Installation
Menu system
page shows
Transceiver IP
295