2-Wire Acceleration, Pressure, Or Piezoelectric Velocity Sensors - Allen-Bradley 1444-TSCX02-02RB User Manual

Chapter 2 Install the Dynamix 1444 Series Monitoring System
68
Figure 24 - Channel 3 Wiring
Driver
Shield Floating
* Shield can be landed to any available shield connection. See the IMPORTANT note on

2-wire Acceleration, Pressure, or Piezoelectric Velocity Sensors

The channel must be configured for a positive, constant current supply and the
transducer power output must be connected to the spare signal connection
(link terminals 1 and 2 in channel 0, see
terminals for each channel follows.
Typical Core Designation
SIG (+)
Return (-)
Then link these terminals:
Figures 25...28 show typical wiring for 2-wire constant current sensors
including IEPE Acceleration, Velocity, and Pressure Sensors.
Figure 25 - 2-wire IEPE Sensors Channel 0 Wiring
* Shield can be landed to any available shield connection. See the IMPORTANT note on
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Common 16
14 or 15
Signal Output
31*
Shield
-24V DC
13
page 56
Figure 24). A list of appropriate
Channel 0 Channel 1
3 7
4 8
1 and 2 5 and 6
Pin A - Signal
Pin B - Common
Cable shield not
connected at this end
Common
4
3
Signal
19*
Shield
page 56
64 49
33
48
16
1
32
17
13 31 14 16
for additional information.
Channel 2 Channel 3
11 15
12 16
9 and 10 13 and 14
49
64
48 33
16
1
32
17
1 - 2 19 3
4
jumper
for additional information.