Relay Status Structure - Allen-Bradley 1444-TSCX02-02RB User Manual

Chapter 10 Operate the Module
286
The example indicates the status of voted alarm number 2.
However, the voted alarm instance that is provided in the status assembly is a
value from 1...13. To get the voted alarm instance, as referenced to the AOP
(0...12), subtract 1 from the decimal value of the presented 4-bit value.
Table 68 - Alarm Status Structure
The status structure consists of these parameters.
DINT
INT
INT
The data type for each attribute is either an 'INT' (16 bits), or a 'DINT' (32
bit). In each case, the state of the individual bits, as provided in
the status. It is possible for multiple bits to be set.

Relay Status Structure

The relay status structure contains the parameters that are shown in
It communicates the status of the single on-board relay (relay 0) of the dynamic
measurement module. It also communicates the status of the relays in each of
the up to three connected expansion relay modules (relays 1...4, 5...8 and
9...12). The table consists of discrete bits, one per relay. When set, the bit
indicates that the associated relay is energized.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
AlarmStatus [13]
Relay
Reserved
Table 67, define
Table 69.