Allen-Bradley 1444-TSCX02-02RB User Manual page 522

Appendix A CIP Objects
522
Table 276 - Channel / Tacho / Speed Status
Bit Description
0 Channel 0 Enabled.
1 Channel 1 Enabled.
2 Channel 2 Enabled.
3 Channel 3 Enabled.
4 Transducer 0 Enabled.
5 Transducer 1 Enabled.
6 Transducer 2 Enabled.
7 Transducer 3 Enabled.
8 Transducer 0 Faulted.
9 Transducer 1 Faulted.
10 Transducer 2 Faulted.
11 Transducer 3 Faulted.
12 Transducer 0 Wire Off Detected.
13 Transducer 1 Wire Off Detected.
14 Transducer 2 Wire Off Detected.
15 Transducer 3 Wire Off Detected.
Table 277 - Relay Expansion Module 0 / 1 Status
Bit Description (Expansion Relay Module 0) Bit
0 Relay module not responding. If set
disregard other bits in this group.
1 Module is configured (so normally expected
set).
2 Code CRC fault.
3 High temperature warning.
4 Link/bus fail.
5 Halt is active.
6 RAM fault.
7 RAM access error.
8 Relay 0 not inhibited (so normally set).
9 Relay 1 not inhibited.
10 Relay 2 not inhibited.
11 Relay 3 not inhibited.
12 Relay 0 drive failure.
13 Relay 1 drive failure.
14 Relay 2 drive failure.
15 Relay 3 drive failure.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Bit Description
16 Speed 0 Enabled.
17 Speed 1 Enabled.
18 Speed 0 Faulted.
19 Speed 1 Faulted.
20 Bit toggles on new maximum speed
detected on Speed 0.
21 Bit toggles on new maximum speed
detected on Speed 1.
22 Redundant speed fault, speed source has
switched.
23 Spare
24 Channel 0 Calibration Error.
25 Channel 1 Calibration Error.
26 Channel 2 Calibration Error.
27 Channel 3 Calibration Error.
28 Spare
29
30
31
Description (Expansion Relay Module 1)
16 Relay module not responding. If set
disregard other bits in this group.
17 Module is configured (so normally expected
set).
18 Code CRC fault.
19 High temperature warning.
20 Link/bus fail.
21 Halt is active.
22 RAM fault.
23 RAM access error.
24 Relay 0 not inhibited (so normally set).
25 Relay 1 not inhibited.
26 Relay 2 not inhibited.
27 Relay 3 not inhibited.
28 Relay 0 drive failure.
29 Relay 1 drive failure.
30 Relay 2 drive failure.
31 Relay 3 drive failure.