Allen-Bradley 1444-TSCX02-02RB User Manual page 25

ATTENTION: If you use this equipment in a manner that the manufacturer
has not specified, the protection that is provided by the equipment can be
impaired.
Before you install, configure, operate, or maintain this product, read this
document and the documents that are listed in the additional resources section.
The documents provide additional information about how to install, configure,
or operate the equipment. You must familiarize yourself with installation
instructions and instructions for wiring, and requirements of all applicable
codes, laws, and standards.
Suitably trained personnel must install, adjust, implement, use, assemble,
disassemble, and maintain the equipment in accordance with applicable code of
practice. If there is a malfunction or damage, do not attempt to make a repair.
The module must be returned to the manufacturer for repair. Do not dismantle
the module.
This equipment is certified for use only within the surrounding air temperature
range of -25...70 °C (-13...158 °F). The equipment must not be used outside of
this range.
Solid-state equipment has operational characteristics that differ from
electromechanical equipment operational characteristics.
Publication SGI-1.1, Safety Guidelines for the Application, Installation, and
Maintenance of Solid-State Controls, is available from your local Rockwell
Automation sales office or online at http://www.rockwellautomation.com/
literature. This publication describes some important differences between solid-
state equipment and hard-wired electromechanical devices.
WARNING: This equipment is not resistant to sunlight or other sources of UV radiation.
Exposure to some chemicals can degrade the sealing properties of materials that are used in the
following devices:
• DYN module – Relay RL1, Epoxy
• Expansion Relay Module – Relay RL1 through RL4, Epoxy
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Install the Dynamix 1444 Series Monitoring System Chapter 2
25