Allen-Bradley 1444-TSCX02-02RB User Manual page 201

Table 43 - Output Configuration Page Measurement Selection Options
Measurement
Overall (0/1), Channel 0...3
DC(V), Channel 0...3
Order magnitude (0...4), Channel
0...3
Order Phase (0...4), Channel 0...3
FFT Band (0...8), Channel 0...3
Not 1X, Channel 0...3
DC Channel 0...3
SMAX magnitude, Channel Pair 0/1,
2/3
SMAX Phase, Channel Pair 0/1, 2/3
Shaft Absolute pk-pk, Channel Pair 0/
1, 2/3
Speed (0/1)
Factored Speed (0/1)
Speed maximum (0/1)
Speed Rate of Change (0/1)
Axial Differential Expansion, Channel
Pair 0/1, 2/3
Ramp Differential Expansion, Channel
Pair 0/1, 2/3
Rod Drop 0...3
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Configure Analog Outputs
Channel Type Measurement Type
Dynamic, gSE Any
Static Eccentricity
Dynamic, gSE Any
Dynamic Any
Order is Enabled
Dynamic Any
Order is Enabled
Order value is an integer (no fractions)
Dynamic, gSE Any
FFT Band is Enabled
Dynamic Any
Order 0 is Enabled
Order 0 value = 1.0
Static Any
Dynamic X (shaft relative),
Y (shaft relative), Aeroderivative.
Shaft Relative (LP/HP filtered)
Dynamic CH A =
Shaft Relative (LP/HP filtered)
CH B =
Std. case absolute vibration (AV to D)
or
Std. case absolute vibration (V to D)
If Speed input is Enabled Any
Static CH A = Complementary Differential
Expansion A
CH B = Complementary Differential
Expansion B
Static CH A = Ramp Differential Expansion A
CH B = Ramp Differential Expansion B
Static Rod Drop
Chapter 6
201