Ethernet Port Status Indicators - Allen-Bradley 1444-TSCX02-02RB User Manual

OS Operating Powered off
Status
DSP DSP Run Powered off
OK DSP Status Powered off
or channels
are disabled
during the
configuration
transfer
process
CH0 Channel 0 Channel
status disabled
CH1 Channel 1 Channel
status disabled
CH2 Channel 2 Channel
status disabled
CH3 Channel 3 Channel
status disabled
RLY Relay status Relay not in
use
OK / Normal Redundant If DSP Status
power fail Indicator is
flashing
green:
Configuring
If DSP Status
Indicator is
solid green or
off: Storing
to memory
DSP paused DSP running —
or not
running
OK — —
Channel OK/ — —
TX OK
Channel OK/ — —
TX OK
Channel OK/ — —
TX OK
Channel OK/ — —
TX OK
Relay not in — Relay
alarm inhibited

Ethernet Port Status Indicators

Each Ethernet port RJ45 jack is fitted with two status indicators.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
— Inhibit —
Setpoint — DSP is in boot
Multiplier loader mode
active
— Calibration, —
DSP, or
configuration
error
— Channel TX —
Fault
— Channel TX —
Fault
— Channel TX —
Fault
— Channel TX —
Fault
— Relay in —
alarm
(actuated)
Operate the Module Chapter 10
Firmware —
update in
process
— —
Firmware —
update in
process
— —
— —
— —
— —
— —
309