Table of Contents
Advertisement
Chapter 10
Operate the Module
Updating Module Firmware
246
3. When ready, re-establish the connection by uninhibiting the module.
When the connection is re-established, the controller updates the
module with the current configuration.
To update the firmware in the 1444 series main module and any connected
expansion modules, use ControlFLASH™.I
IMPORTANT Requires ControlFLASH version 14.01 or greater.
TIP To identify the firmware revisions that are currently installed in Dynamix™
Main and expansion modules, see
When it is necessary to update firmware in connected expansion modules a
separate, unique, firmware update must be executed. If firmware updates are
provided using standard ControlFLASH update packages, see
Expansion Module Firmware on page
To update the firmware in a Dynamix 1444 Series (main) module, follow these
steps.
1. A reset is used for the module before updating the firmware, depending
on the current firmware revision.
Table 48 - Reset Requirements
Installed Version
Reset Requirement
Type
2.001.x
Out-of-Box
2.002.1
3.002.x+
Not Required
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Status
Page.
Updating
249.
Hardware
Remote
"888"
Types 1 or 2
Hide quick links:
Advertisement
Table of Contents
