Allen-Bradley 1444-TSCX02-02RB User Manual page 507

Table 258 - Class Attributes (continued)
Attribute ID Access Rule
20 Get
21 Get
22 Get
23 Get
Main Module Tacho
24 Get
Main Module Opto Outputs 0/1
32 Get
33 Get
Main Module Local Onboard Relay
39 Get
40 Get
41 Get
42 Get
43 Get
44 Get
64 Get
Channel 0 DSP FFT
72 Get
73 Get
NV Name
NV NetX Firmware Build
NV DSP Firmware Build
- DSP Configuration CRC
- NetX/DSP Error Status
V Tacho Mode
V Opto Output 0 Allocation
V Opto Output 1 Allocation
V Auto Local Relay Control
NV User Local Relay Control
NV Local Relay Control
V Relay Source
V Relay Drive Test Enable
V Relay Drive Test
Interval
V Redundant Power Supply
V Enable
V Signal Source
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Data Type Description of Attribute Semantics of Values
SHORT-STRING Build Date (ASCII string)
UDINT Build Version
UINT 16-bit CRC for the DSP and
Auxiliary relevant
configuration
DWORD DSP: bits 0...15 NetX: bits
16...31
A configuration attribute.
SINT Individual or Redundant
Mode
A group of two configuration attributes.
SINT Source configuration for
this Opto-isolated output.
SINT Source configuration for
this Opto-isolated output.
A logical grouping of parameters.
BYTE Configuration of local relay
behavior in case of
detected fault condition,
which is based on
associated voted alarm.
BYTE User configuration of local
relay behavior in case of
detected fault condition.
BYTE Actual behavior of local
relay in case of detected
fault condition.
SINT Link to corresponding
voted alarm object
(instance and output
type).
BOOL Whether the relay drive
circuit is being routinely
tested.
UINT Test interval.
SINT Whether the module is
being powered
redundantly.
Group of seven configuration attributes.
SINT An enable control. Only
enable if FFT bands are
required from this channel.
SINT Defines the data source.
CIP Objects Appendix A
for example, length 0x0B 56, 65, 70,
20, 31, 37
Sep 17
20, 32, 30, 31, 34
2014
for example, 10034 is V1.00.34
Is unchanged if configuration
changes are limited to CM features
Normal (no error) status = 0
Bit 0 - DSP Not responding
Bit 1 - DSP in boot loader mode
Bit 2 - Configuration process failed
to complete
Bit 16 - Corrupt object file detected
0: Individual
else Redundant Tacho Mode
Opto source
Opto source
Returns 0 if relay source is not a
voted alarm
Relay control
Relay control
Relay control
Relay source decoding
Automatic on fail-safe setting
ms
0: Not redundant
1: Redundant
0: Disable
1: Enable
Source
507