Start The Module And Perform A Self-Test - Allen-Bradley 1444-TSCX02-02RB User Manual

Chapter 2 Install the Dynamix 1444 Series Monitoring System
Start the Module and
Perform a Self-test
88
After the modules are wired, power can be applied to test the installation. At
power-up, each module performs an initial Self-test.
After the Self-test cycle the modules move to an idle state until a configuration
is downloaded, and a connection is made to a controller.
status indicators:
Table 11 - Dynamic Measurement Module
Status Color Behavior
Indicator
PWR Green Solid
RUN Green Flashing
MS Green Solid
NS Green Solid or Flashing
OS Green Solid
If the status indicators are not as shown in
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Table 11
Status Color Behavior
Indicator
DSP Green Flashing
OK Green Solid
CH0 Green Solid
CH1 Green Solid
CH2 Green Solid
CH3 Green Solid
RLY Green Solid
Table 11, see Table 79 on page
describes the
308.