Allen-Bradley 1444-TSCX02-02RB User Manual page 106

Chapter 3 Configure the 1444 Dynamic Measurement Module
Table 16 - Input Data
Parameter Values
Not 1x Checked (1)
Unchecked (0)
Proportional DC Checked (1)
Unchecked (0)
Rod Drop Checked (1)
Unchecked (0)
106
Comments
Check this parameter to include the Not 1x member for the selected channel to the input tag.
Channel Tag Member
0 Ch0Not1X
1 Ch1Not1X
2 Ch2Not1X
3 Ch3Not1X
Check this parameter to include the Proportional DC member for the selected channel to the input tag.
Channel Tag Member
0 Ch0DC
1 Ch1DC
2 Ch2DC
3 Ch3DC
• The tag value displays in the specified engineering units for the proportional value.
• If the channel type is DC, then only one DC member can be selected (Axial or Radial Differential Expansion, DC
Proportional, or Rod Drop).
Check this parameter to include the Rod Drop member for the selected channel to the input tag.
Channel Tag Member
0 Ch0RodDrop
1 Ch1RodDrop
2 Ch2RodDrop
3 Ch3RodDrop
If the channel type is DC, then only one DC member can be selected (Axial or Radial Differential Expansion, DC
Proportional, or Rod Drop).
Select Input Data for Input Tag
The parameters on this page are used to specify measurements to be included
in the Input Tag. When a control is checked, the corresponding member is
included in the input tag.
The page is organized into top (Module level), middle (Input Pair level) and
bottom (Input level) sections.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018