Allen-Bradley 1444-TSCX02-02RB User Manual page 107

Module Level Parameters
The parameters in the top section are all associated with speed so they are not
dependent on the configuration or availability of any measurement channel.
Channel Pair Level Parameters
The parameters in this section are measurements that are made from two
measurement channels. The two channel measurements are made from
channels that are grouped into either of two pairs; channels 0 and 1 or channels
2 and 3.
There are two versions of each of the parameters that are shown in this section,
one associated with each channel pair. Click the button for pair 0, 1 or pair 2, 3
to select the measurements for either pair.
Channel Level Parameters
The parameters in this section are measurements that are made from individual
channels.
There are four versions of each of the parameters that are shown in this section,
one associated with each channel. Click the button for channel 0 or 1, for
channel pair 0/1, or 2 or 3, for channel pair 2/3, to select the measurements for
each channel:
• The parameters on this page are used only by the AOP.
• The Module Personality and Channel Type selections of the Define
Module Functionality page filter the presented measurements.
• To select measurements on this page forces related configuration
definition/selections but cannot verify that the configuration of the
measurement is appropriate for the application and the applied signals.
• Use the Copy button to copy the Channel Pairs and Channel selections
that are visible to the other Channel Pair and Channels.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Configure the 1444 Dynamic Measurement Module Chapter 3
107