Table of Contents
Advertisement
Mount the Terminal
Base Unit
The following generic DIN rail mounting scheme applies to all terminal base
mounting.
Dynamix 1444 Series terminal bases are mounted using two pairs of screws, the
"DIN rail set screws" and the "Bottom set screws" (see
that are included are as follows:
Table 6 - Dynamix 1444 Series Terminal Base Screws
Application
Type
DIN rail set screws
DIN7985
Bottom set screws
DIN7985
The screw lengths are designed to accommodate mounting to standard 35 x 7.5
mm (1.38 x .30 in.) DIN rail. If mounting directly to a panel, or otherwise
require another length screw, then the screws that are provided can be replaced.
1. Hook the base assembly from the bottom under the DIN rail. The
presence of coding switches identifies the bottom side of the terminal
base.
2. Hook over the top and let gravity drop the terminal base into place.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Install the Dynamix 1444 Series Monitoring System
Figure
Thread
Length
M3x0.5 mm
20 mm (0.787 in)
M3x0.5 mm
22 mm (0.866 in)
Chapter 2
5). The screws
Phillips Drive
#1
#1
43
Hide quick links:
Advertisement
Table of Contents
