Allen-Bradley 1444-TSCX02-02RB User Manual page 217

Table 45 - Alarms (continued)
Parameter Values
Alert High Any
Limit
Alert Low
Limit
Danger High Select from:
Output Tag • O.AlarmLimit[0]
Limit • O.AlarmLimit[1]
• ...
Alert High
• O.AlarmLimit[15]
Output Tag
Limit
Alert Low
Output Tag
Limit
Danger Low
Output Tag
Limit
Limit ≥0...1000.000
Multiplier
Help
Enter a value to specify the limit that when the measurement is above/below (unsafe direction) defines
an Alert Alarm condition.
Select the controller output tag for the alarm limit that is referenced.
Select the controller output tag for the alarm limit that is referenced.
For Static Limits (normal mode), enter the multiplier that is applied when the Setpoint Multiplier
function is set.
The Limit Multiplier field does not display if you select "Static Limits Without Adaptive Multipliers" from
the Apply Limits From pull-down menu.
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Configure Alarms Chapter 8
217