Relay Output
There is one single pole double throw (SPDT) relay that is included in the
DYN module with the three contact connections being made available at the
terminals. A typical purpose for this module relay is to signal module status.
See
Figure 84 on page
35
34
33
NC
C
NO
NC – Normally closed
C – Common
NO– Normally open
'Normal' is the relay contact state when unpowered.
Figure 13 - Wiring Relays
Rockwell Automation Publication 1444-UM001D-EN-P - June 2018
Install the Dynamix 1444 Series Monitoring System
209.
Chapter 2
57