Jeep J-10 Series 1982 Technical & Service Manual page 715

TRANSFER CASE 2D-39
rtfriV gauMJjUS^X't VTrttfftHn
REAR SHAFT
OUTPUT GEAR
REAR SHAFT
CLUTCH SLEEVE
REAR SHAFT
CLUTCH GEAR
FRONT SHAFT
CLUTCH GEAR
FRONT
OUTPUT
SHAFT
F3CNT OUTPUT
SHAFT GEAR
FRONT SHAFT
CLUTCH SLEEVE
Fig. 2D-70 Power Flow—Model 300
16) Remove oil seal using Tool J-25180 (fig. 2D-75).
(7) Lp.; gplacement seal using Tool J-25160.
(8) it's: >ke, iasher and nut. Tighten nut to 120
foot-pounds 163 S*mi torque. Use Tool J-8614-01 to
hold yoke • rule tightening nut.
Rear Bearing Cjp—Speedometer Drive Gear Service
Removal
i L) Disconnect rear propeller shaft at transfer case
yoke. Tie shaft to frame with wire.
i2) Disconnect speedometer cable.
i:\) Remove speedometer driven gear sleeve and
driv i-:i gear.
11) Renin ••• i ransfer case vent hose.
(.*>) Remo> •• output shaft yoke using Tools J-8614-01,
iHi Remc
renin •: bearint
hearing cap-to-transfer case bolts and
.•an.
NOTE: The fn ••> >,,:/ rap has been coated with a sealant,
(si ,i nutty kiiifi tn break the seal, and work the knife
around tin bt ariug ••.,,> tn loosen and remove it.
TOOL
J-25175
Fig. 2D-71 Shift Rod Oil Seal Removal
J42361