Jeep J-10 Series 1982 Technical & Service Manual page 1106

DIVISION CHANNEL
GLASS SLIDE CHANNEL
GLASS
SHIMS
STATIONARY
FRAME
tfDOW
IAME
REGULATOR
SEALER
RIVET
RETAINER
HANDLE
42656
Fig. 3J-5 Rear Door—Cherokes-Wagonser Models
Vent Window
Removal
(1) Remove door glass.
(2) Apply soap solution under vent weatherstrip
and along inner and outer door panels.
(3) Slide vent assembly forward to center of door
glass opening.
(4) Push vent assembly down through opening be
tween inner and outer door panels to disengage assem
bly from upper door frame.
(5) Lower top of vent assembly down to clear upper
door frame.
(6) Pull vent assembly straight up until weather-
seals are clear of door panel and vent assembly can be
rotated.
(7) Rotate assembly to position lower attaching
bracket on channel and pull assembly up and out be
tween panels.
Installation
(1) Install assembly between panels.
(2) Engage vent assembly in upper door frame and
slide vent into position.
(3) Install attaching hardware.
(4) Install door glass.
Window Regulator
Removal
(1) Remove door trim panel and water shield.
(2) Apply masking tape to each side of glass over
top of window frame to hold glass during regulator
removal.