Side Rail - Jeep J-10 Series 1982 Technical & Service Manual

3L-16 HARDTOP ENCLOSURE-SUN ROOF AND LUGGAGE RACKS
J41007
Fig. 3L-19 Luggage Rack—Cherokes-Wagonear Models
ADJUSTARLE END RAIL
Removal
(1) Remove screws attaching end supports to side
rails.
(2) Remove attaching screws from end supports and
remove supports.
NOTE: Do not apply extreme pressure to support at
taching screws during removal or installation as this
may cause the well nuts to drop between the roofpanel
and headliiier.
(3) Loosen adjustable end rail locknuts and remove
adjustable end rail from side rails.
Installation
(1) Position adjustable end rail in side rails.
(2) Position end supports on side rails.
(3) Position end supports and gaskets on roof.
(4) Coat screw threads with 3M Drip-Check Sealer,
or equivalent, and install screws. Tighten screws to 28
inch-pounds (3 N«m) torque.
(5) Install screws attaching end supports to side
rails.
(6) Tighten adjustable end rail locknuts.
SIDE RAIL
Removal
(1) Remove screws attaching side rail to supports.
(2) Remove screws attaching end support to roof.
NOTE: Do not apply extreme pressure to support at
taching screws during removal or installation as this
may cause the well nuts to drop between the roof panel
and headliner.
(3) Remove end support and side rail.
Installation
(1) Position side rail on supports.
(2) Position end support and gasket on roof.
(3) Coat screw threads with 3M Drip-Chek Sealer or
equivalent, and install screws. Tighten screws to 28
inch-pounds (3 N*m) torque.
(4) Install screws attaching side rail to supports.