Seat Belts - Jeep J-10 Series 1982 Technical & Service Manual

3M-4 SEAT ASSEMBLIES
RIGHT
LATCH LEVER
BRACE
J41198
Fig. 3M-3 Frost S«tt Adjotrnwt
(2) Tighten turnbuckle until slack is removed from
wire.
(3) Back off turnbuckle three turns.
(4) Secure wingnut up against turnbuckle.
(5) Check for proper seat adjustment operation. If
right side of seat will not release, increase tension by
tightening turnbuckle. If right side of seat will not lock
in place,decrease tension by loosening turnbuckle.
CJ AND SCRAMBLER FLOOR CONSOLE
The beverage container type floor console (fig. 3M-4),
available only with bucket seat equipped models, is fab
ricated from molded plastic material. The floor console
cover is provided with a lock and two depressions de
signed to hold beverage containers. The bottom of the
floor console is equipped with a hole, in the rear, allow
ing ice water to drain onto the ground.
The oval head key is utilized to lock and unlock the
cover.
Reaovil
(1) Open console cover.
(2) Remove screws attaching console to floorpan.
(3) Remove console assembly from vehicle.
Installation
(1) Position console assembly in vehicle.
(2) Align drain hole with hole in floorpan and in
stall attaching screws.
(3) Close and latch console cover.
Console Cover Seal
The console cover seal is attached to the console. The
foam seal may be replaced after opening the cover.
Console Cover Lock
Lock Cyllader Renoval
(1) Open console cover.
(2) Remove screw attaching retainer to lock. Re
move retainer from lock.
(3) Remove lock, cylinder and key as unit from
cover.
(4) Manually set latch to simulate closed cover posi
tion, turn key and cylinder counterclockwise and lift out
of lock.
RETAINER
CYLINDER
COVER
80085
Flfl. 3M-4 Floor Console Conpooeots
LockCytlioarlaitatlitloo
(1) Manually set latch to simulate closed cover
position.
(2) Insert key and cylinder into lock and turn clock
wise. Release latch and remove key.
(3) Position assembled lock in cover and install re
tainer and attaching screw.
SEAT BELTS
Removal
(1) Remove seat belt anchor bolt with Torx Bit Tool
J-25359-C.
(2) Remove seat belt.
(3) Remove shoulder belt guide cover from guide, if
equipped.
(4) Remove guide bolt with Torx Bit Tool J-25359-C.
(5) Obtain access to seat belt retractors by remov
ing trim covers.
(6) Remove seat belt retractors anchor bolts with
Torx Bit Tool J-25359-C.
(7) Remove seat belt retractor.
(8) Inspect seat belt material for evidence of wear,
cuts, or fraying. Replace as required.