Jeep J-10 Series 1982 Technical & Service Manual page 1070

3F-20 BODY AND FRAME COMPONENTS
BRUSH
GUARD
80441A
Rg.3F-29 Brisk Oifja^-dMrttkao-Track Models
NOTE: Do not tighten attaching hardware until com
plete brush guard is assembled on vehicle andproperly
aligned
(2) Install bolts and washers attachingbrush guard
to frame rails.
(3) Align brush guard assembly and tighten all at
taching hardware.
(4) Install and connect fog lamps, if equipped.
SOFT TOP WITH METAL
DOORS-CI AND
SCRAMBLER MODELS
GENERAL
A soft top with metal doors is available on the CJ-7
and Scrambler models. This option offers the conven
ience of a soft top with the security of metal doors. The
adjustment of the doors remains the same as if equipped
with a hard top.
See Chapter 3J for door and window service
procedures.
It is possible to adjust the soft top at the rear of the
door to achieve an air-tight seal between door and soft
top.
ADJUSTMENT
(1) Unsnap soft top from vertical support blade(fig.
3F-30).
(2) Loosen adjusting screws.
(3) Reposition vertical support blade.
(4) Tighten adjusting screws.
(5) Reposition and snap soft top into place.
/SB*