Retainer Bushing Replacement; Clutch Retainer Bushing Removal—Model 999 - Jeep J-10 Series 1982 Technical & Service Manual

2C-50 AUTOMATIC TRANSMISSION
Inspect the band application surface on the clutch
retainer for nicks and scores. Light scratches and nicks
can be removed with crocus cloth.
Inspect the ball check in the clutch retainer. The ball
should move freely in its cage.
Inspect the seal ring surfaces inside the clutch re
tainer for nicks or deep scratches. Light scratches will
not interfere with sealing of the rings. Inspect the clutch
retainer bushing for scores and wear and inspect the
inner bore surface for wear and inspect the inner bore
surface for wear from the reaction shaft support seal
rings and lands.
Inspect the inside of the piston bore for score marks.
Remove light scores with crocus cloth. Inspect the seal
ring grooves for nicks and burrs. Inspect the piston
spring, retainer, and snap ring for distortion.
Retainer Bushing Replacement
(1) Place clutch retainer, with open end facing
down, on a clean, smooth surface.
(2) Insert Bushing Remover/Installer Tool J-24064
in bushing (fig. 2C-69).
(3) Install Driver Handle J-8092 in remover tool and
drive bushing straight down and out of retainer bore.
(4) Position clutch retainer so open end faces
upward.
(5) Install replacement bushing on tool and install
bushing straight into retainer bore until bushing is flush
with base of bore chamfer (fig. 2C-70).
TOOL
J-8092
41831
Fig. 2C-69 Clutch Retainer Bushing Removal—Model 999
TOOL
J-8092
41832
Fig. 2C-70 Clutch Retainer Bushing Installation—Model 999
Assembly
(1) Lubricate inner seal with petroleum jelly and
install seal on hub of clutch retainer.
NOTE: Be sure the seal lip is facing into the piston bore
and that the seal is properly seated in the retainer
groove.
(2) Lubricate outer seal with petroleum jelly and
install it on clutch piston so seal lip faces into piston
bore.
(3) Install piston assembly in retainer using a twist
ing motion to seat piston at bottom of bore.
(4) Install spring on piston hub and spring retainer.
(5) Install snap ring over spring.
(6) Install Spring Compressor Tool J-5886-01 over
retainer assembly.
(7) Compress spring and seat snap ring in clutch
hub groove.
(8) Remove compressor tool.
(9) Lubricate clutch plates and discs with transmis
sion fluid.
(10) Install one steel plate followed by a lined plate
until proper number of plates are installed.
(11) Install pressure plate and waved snap ring.
NOTE: Be sure snap ring is completely seated in
groove.
(12) Measure clutch pack clearance using feeler
gauge.