End Play Measurement; Oil Pump Seal Installation; Transmission Holding Fixture; 34 Automatic Transmission - Jeep J-10 Series 1982 Technical & Service Manual

2C-34 AUTOMATIC TRANSMISSION
(5) Raise transmission and align converter with
drive plate. Refer to assembly alignment marks.
(6) Move transmission forward.
(7) Raise, lower or tilt transmission to align con
verter housing pilot holes with dowels in engine.
(8) Install two converter housing lower attaching
bolts and tighten bolts to pull housing to engine.
(9) Install drive plate-to-converter attaching bolts.
(10) Install remaining converter housing-to-engine
attaching bolts. Tighten all bolts to 28 foot-pounds (38
N«m) torque.
(11) Connect oil cooler lines.
(12) Install rear support cushion on transmission.
(13) Raise transmission and install rear cross-
member.
(14) Remove transmission jack.
(15) Install speedometer cable.
(16) Install inspection cover.
(17) Install exhaust pipes and support brackets, if
removed.
(18) Install starter.
(19) Connect wires to neutral switch.
(20) Connect gearshift and throttle linkage.
(21) Install propeller shafts. Refer to alignment
marks made during removal/
(22) Connect front exhaust pipes and catalytic con
verter support bracket bolts, if removed.
(23) Fill transfer case to correct level with specified
lubricant.
(24) Lower vehicle.
(25) Fill transmission to correct level as described in
Fluid Level and Condition.
(26) Adjust gearshift linkage.
(27) Road test to check transmission operation.
TRANSMISSION DISASSEMBLY
CAUTION: Cleanliness during disassembly and as
sembly is necessary to avoid a further malfunction after
assembly. Before removing any of the transmission sub
assemblies, plug all openings and thoroughly clean the
transmission exterior. Steam cleaning equipment is
preferable for this purpose. During disassembly, clean
all parts in a suitable solvent and dry each part using
compressed air. Do not use cloth or paper towels to dry
any parts after cleaning, use compressed air only.
End Play Measurement
NOTE: Measuring end play before disassembly will in
dicate whether a thrust washer change is required and
save time at assembly.
(1) Mount transmission in Holding Fixture J-24026
(fig. 2C-36).
Fig. 2C-35 Oil Pump Seal Installation
(2) Remove one pump attaching bolt and thread
Dial Indicator Support Rod J-5864 into bolt hole.
(3) Attach Dial Indicator J-8001 to rod.
(4) Position indicator stylus against forward end of
input shaft (fig. 2C-37).
Fig. 2C-36 Transmission Holding Fixture
(5) Move input shaft rearward and set dial indicator
at zero.
(6) Pull input shaft forward to obtain end play
reading.
(7) Record reading for assembly reference.
(8) Remove dial indicator and rod.
~
* •
- *
~