Fuse Panel; Circuit Breakers - Jeep J-10 Series 1982 Technical & Service Manual

LIGHTING SYSTFMS 38-15
STEERING
COLUMN
STEERING
ACCESSORY COLUMN
STEERING WHEEL
<^
STANDARD COLUMN
IGNITION SWITCH
STEERING WHEEL
<^
TILT COLUMN
POSITION
CIRCUIT
START 1-1, B-1 &S
G-1.G-2
CONNECTED
GROUNDED
ON
1-1 8e B-1
A&B-2
1-3&B-3
CONNECTED
CONNECTED
CONNECTED
OFF
OPEN
OFF-LOCK
OPEN
ACCESSORY
A& B-2 CONNECTED
B-1, B-2 & B-3 (COMMON CONNECTION)
Fig. 3R-25 Ignition Switch Positions
A42215
(4) Hold key in Accessory position and push switch
down column slightly to remove slack in actuator rod.
(5) Tighten attaching screws securely.
(6) Connect white connector and then black con
nector to switch.
(7) Install steering tube cover.
Tilt Column
(1) With actuator rod disconnected, position switch
as shown in figure 3R-25.
(2) Move slider to extreme right (Accessory
position).
NOTE: The right side of the ignition switch is down
ward from the steering wheel.
(3) Position actuator rod in slider hole.
(4) Install switch to steering column but do not
tighten attaching screws.
(5) Lightly push switch down column (away from
steering wheel) to remove lash in actuator rod, while
holding key in Accessory position. Be careful no* to
move slider out of detent.
(6) Tighten attaching screws securely.
(7) Connect white connector and then black con
nector to ignition switch.
(8) Install steering tube cover, if removed.
FUSE PANEL
The fuse panel is located on the passenger com
partment side of the dash panel, attached to the main
harness connector (figs. 3R-26 and 27).
CIRCUIT BREAKERS
CJ and Scrambler Models
Headlamps are protected by a 24-amp circuit breaker
located in the headlamp switch.