Jeep J-10 Series 1982 Technical & Service Manual page 926

2L-14 POWER STEERING GEAR AND PUMP
Pump Leak Points and Corrective Action
M i l ' 111
Corrective Action
If leak persists after tightening fitting nut to specified
torque:
a. Loosen nut and rotate tubing to reseat. Tighten nut
again and recheck. If leak persists, replace con
nector seats and hose or O-ring.
b. Remove hose and check sealing face for cracks. If
flare is cracked, replace hose. If not cracked, replace
connector seats.
c. Replace brass connector seats and reface tube flare.
Check threads in pump housing and on fitting nut. If
nut threads are damaged, replace both housing and
nut.
CAUTION: Some pumps may have a metric thread
pressure part fitting that uses an O-ring seal (2L-
7 view B).
Tighten fitting to specified torque. If leak persists, Re
place both O-ring seals
Replace reservoir O-ring.
Replace pump shaft seal.
Fig. 2L-8 Power Steering Pump Leak Diagnosis and Corrective Action
80078
m
m
m
m
-
~
~