Servo Chain Replacement; Servo Cable Replacement; Control Switch Replacement - Jeep J-10 Series 1982 Technical & Service Manual

1H-10 CRUISE COMMAND
Installation
(1) Attach servo and nut to bracket. Tighten with 60
inch-pounds (7 N»m) torque. Ensure ground cable is
positioned on stud.
(2) Maneuver wire harness through dash panel and
connect connector.
(3) Install cable on servo and squeeze clip to retain
cable.
NOTE: Mounting studs are not equally spaced from
hole in servo. Ensure housing is installed correctly.
(4) Connect vacuum hoses.
SERVO CHAIN REPLACEMENT
(5) Open tabs retaining servo cable.
(6) Disconnect chain from bellcrank pin. Remove
chain.
(7) Attach replacement chain to servo-cable, allow
ing seven beads outside tabs. Squeeze tabs together.
(8) Connect replacement chain to bellcrank pin.
SERVO CABLE REPLACEMENT
Removal
(1) Remove clip from pin on bellcrank and remove
chain.
(2) Squeeze tabs that retain cable housing in
bracket and remove cable from bracket.
(3) Remove retaining nuts and cable housing from
servo.
(4) Spread clip that connects cable to servo and
remove.
(5) Spread tabs on chain end of cable and remove
chain.
Installation
(1) Connect chain to cable and squeeze tabs. Allow
seven beads to remain outside cable tab.
NOTE: Beads must be free to rotate.
(2) Attach cable to servo and squeeze clip to retain
cable.
(3) Install cable housing on servo.
NOTE: Mounting studs are not equally spaced from
hole in servo. Ensure housing is installed correctly.
(4) Attach cable housing to bracket. Ensure tabs
are locked in bracket.
(5) Place chain on bellcrank pin and install lock clip.
Seven beads must be visible between bellcrank lock clip
and cable clip.
CONTROL SWITCH REPLACEMENT
The Cruise Command control switch is integral with
the turn signal switch lever. The switch is not repair
able. The switch and wire harness assembly can be re
placed only as a complete unit.
Removal
(1) Remove following items.
(a) Horn button insert
(b) Steering wheel
(c) Anti-theft cover
(d) Locking plate and horn contact
(2) Remove turn signal switch lever and control
switch assembly (allow handle to hang loose outside
steering column).
(3) Remove four-way flasher knob.
(4) Remove holddown screws and turn signal
switch.
(5) Remove trim piece from under steering column.
(6) Disconnect four-wire connector.
(7) Tilt Column—Remove wires from plastic con
nector. Fold back and tape two of four wires to wire
harness. Tie or tape string to wire harness.
(8) Standard Column—-Tie or tape string to plastic
connector.
(9) Remove lever and wire harness assembly from
column.
Installation
(1) Test replacement Cruise Command control
switch by connecting to wire harness connector before
installing in steering column. Refer to Control Switch
Continuity Test.
NOTE: When installing, the wire harness must be
routed through the turn signal switch lever opening
because the handle will not fit through the lever
opening.
(2) Remove wires from connector. Fold back and
tape two of four wires to wire harness. Tie or tape wire
harness to string that was attached to original wire
harness before removal.
(3) Pull replacement wire harness down through
steering column. On tilt column, harness must pass
through hole on left side of steering shaft.
NOTE: It may be necessary to loosen steering column
mounting screws for easier routing of harness.