Rear Quarter; Trim Panel - Jeep J-10 Series 1982 Technical & Service Manual

3K-1
REAR QUARTER
Pivot Vent Window—Cherokee
Stationary Window—2-Door Cherokee
Stationary Window—4-Door Cherokea-Wagoneer
Page
3K-1
3K-2
3K-3
TRIM PANEL
NOTE: The metal trim panels are held in place with
clips and sheet metal screws. Remove all attaching
screws to remove panel.
Removal
(1) Remove ash receiver, holder screws and holder,
if equipped.
(2) Remove armrest metal overlay strip, if equip
ped, and remove attaching screws and armrest.
(3) Remove trim panel screws at base of panel, if
equipped.
(4) Pry loose trim panel attaching clips, using Trim
Pad Depressor J-2631-01 and remove panel.
Installation
(1) Inspect all panel attaching clips; replace any
that are bent. To prevent damage to trim panel, do not
hammer or exert excessive force on clips.
(2) Install trim panel attaching screws, if equipped.
(3) Install armrest and armrest metal overlay strip,
if equipped.
(4) Install ash receiver holder and ash receiver, if
equipped.
PIVOT VENT WINDOW—CHEROKEE MODELS
Removal
(1) Remove handle-to-frame attaching screws (fig.
3K-1).
(2) Remove glass hinge screws and washers.
(3) Remove glass.
INDEX
FRAME
Stationary Window—CJ-7 and Scrambler with
Hardtop Enclosure 3K-2
Trim Panel 3K-1
Tools 3K-4
WEATHERSTRIP
STUD
WEATHERSTRIP
GLASS
HINGES 90800
Fig. 3K-1 Rear Quarter Window—Cherokee Models
NOTE: If glass sticks to hinges, remove glass by care
fully pushing out hinge screw inserts.
(4) To remove handle assembly from glass, care
fully drive out handle assembly-to-stud roll pin.
(5) Unscrew stud nut and remove stud from glass.
(6) Remove vent window weatherstrip.
Installation
(1) Install vent window weatherstrip.
(2) Attach glass to frame using hinge screw inserts,
washers and screws.