Jeep J-10 Series 1982 Technical & Service Manual page 1064

3F-14 BODY AND FRAME COMPONENTS
Instillation
(1) Position front bumper rail on frame extension.
(2) Install bolts and nuts attaching front bumper
rail to frame extension.
(3) Install and connect fog lamps, if equipped.
Front Crossmember Cover—CJ and Scrambler Models
Removal
(1) Remove nuts and bolts attaching front cross-
member cover (fig. 3F-18) to frame extensions.
(2) Remove front crossmember cover from frame
extensions.
Installation
(1) Position front crossmember cover on frame
extensions.
(2) Install bolt and nuts attaching front crossmem
ber cover to frame extensions.
Cherokee-Wagoneer-Tnick Models
Removal
(1) Disconnect and remove fog lamps, if equipped.
(2) Remove vertical bumper guards (fig. 3F-19)
from bumper rail, if equipped.
FRONT BUMPER RAIL
(3) Remove horizontal bumper guards from bumper
rail, if equipped.
(4) Remove front air deflector (fig. 3F-19), if
equipped.
(5) Remove nuts and bolts attaching bumper rail to
frame mounted bumper brackets. Remove bumper rail
from vehicle.
(6) Remove nuts and bolts attaching bumper
brackets to vehicle frame. Remove brackets from vehicle
frame.
Installation
(1) Position brackets on vehicle frame and install
attaching bolts and nuts.
NOTE: Do not tighten attaching hardware until com
plete bumper is assembled on vehicle frame and prop
erly aligned.
(2) Position bumper rail on brackets and install at
taching bolts and nuts.
(3) Align bumper assembly and tighten all attach
ing hardware.
(4) Install horizontal bumper guards, if equipped.
(5) Install and connect fog lamps, if equipped.
(6) Install vertical bumper guards, if equipped.
(7) Install front air deflector, if equipped.
LICENSE
PLATE
BRACKET
90177
Fig. 3F-19 Front Bumper—Cherokee-Wagoneer-Treck Models