Clutch Shaft Removal/Installation; Output Shaft Bearing Race Removal; Output Shaft Removal/Installation; Countershaft Rear Bearing Removal - Jeep J-10 Series 1982 Technical & Service Manual

2B-10 MANUAL TRANSMISSION
Fig. 2B-13 Clutch Shaft Removal/Installation
THRUST
RACE
NEEDLE
BEARING (15)
THRUST
BEARING
81199D
81199E
Fig. 2B-14 Clutch Shaft Roller Bearing. Thrust Bearing and
Race Removal/Installation
81199G
Fig. 2B-15 Output Shaft Bearing Race Removal
(3) Remove third-fourth synchronizer blocking
ring, sleeve and hub as assembly. Note position of hub
and sleeve for assembly reference.
(4) Remove third-fourth synchronizer, insert
springs, remove inserts and remove sleeve from hub.
(5) Remove third gear from shaft.
(6) Remove snap ring retaining second gear on shaft
(fig. 2B-22) and remove tabbed second gear thrust
washer and second gear (fig. 2B-23).
(7) Remove output shaft bearing using Puller Set J-
29721 and adapters 293-39 (fig. 2B-24).
(8) Remove first gear thrust washer, first gear roll
pin, first gear and blocking ring (fig. 2B-25). Use diago
nal cutters to remove roll pin.
Fig. 2B-16 Output Shaft Removal/Installation
BRASS
DRIFT
Fig. 2B-17 Countershaft Rear Bearing Removal
199H
81200G