Interior Lighting - Jeep J-10 Series 1982 Technical & Service Manual

(8) Position bezel on lamp body and install attach
ing screws.
(9) Install stone shield on lamp.
Switch Replacement
(1) Remove switch from instrument panel and dis
connect electrical harness (fig. 3R-17).
BULB HOLDER
BULB
SWITCH
BRACKET
80636
Fig. 3R-17 Fog Lamp Switch Components
(2) Connect harness to replacement switch and in
stall switch in instrument panel.
LIGHTING SYSTEMS 3R
ENGINE COMPARTMENT LAMP
This optional lamp obtains current at the battery
minal of the starter solenoid. A single wire
corporating a fusible link for protection passes curr
to the lamp assembly. The lamp assembly has a mere
switch which completes the circuit through the h
assembly when the hood is open. When the hoot
closed, the mercury within the lamp assembly opens
circuit and the lamp does not light (fig. 3R-18).
SPLICE
ENGINE COMPARTMEN"
LAMP ASSEMBLY
CONNECTOR
I J
SSSSTd -Q^nk-Ublack^-
f
BATTERY
H pos -
t )(
GROUNDS
THROUGH
HOOD
ASSEMBLY
Fig. 3R-18 Engine Compartment Lamp Wiring
604;
INTERIOR LIGHTING
SYSTEM
Page
Cargo Lamps 3R-13
Courtesy Lamps/Dome Lamps 3R-11
Dome/Reading Lamp 3R-12
COURTESY LAMPS/DOME LAMPS
CJ and Scrambler Models
CJ and Scrambler models equipped with the hardtop
have a dome lamp located above the liftgate. When
removing the hardtop, disconnect the wire connector
located on the left C-pillar. On the CJ-7 limited model,
the dome lamp and courtesy lamps are operated by door
pillar switches. On all other models, the lamp is oper
ated by turning the headlamp switch knob counter
clockwise to the stop.
The dome lamp lens can be removed by squeezing the
lens together to disengage the retaining tabs (fig. 3R-19).
The dome lamp assembly can be removed after remov
ing the attaching screws.
Cherokee-Wagoneer Models
The courtesy and dome lamps operate when the doors
are opened. The door pillar switch provides a ground for
the circuit.
Glove Box Lamp
Instrument Cluster Lamps
MOUNTING BRACKET
Fig. 3R-19 Dome Lamp—CJ and Scrambler Models
Battery feed is from the headlamp switch. Wher
doors are closed, the dome and courtesy lamps are c
ated by rotating the headlamp switch knob coui
clockwise to the stop. The ground for the lamps is
through the headlamp switch. The standard round d
lamp lens has three irregularly spaced barbed tabs
are inserted into slots in the dome lamp base to reta:
The lens is removed by pulling it downward or by pr
it down with a small screwdriver (fig. 3R-20).