Specifications - Jeep J-10 Series 1982 Technical & Service Manual

2B-18 MANUAL TRANSMISSION
NOTE: The offset lever and shift rail roll pin holes
should be aligned and in a vertical position following
completion ofStep 35.
(37) Install and tighten adapter housing retaining
bolts to 25 foot-pounds (34 N«m) torque.
(38) Install roll pin in offset lever and shift rail (fig.
2B-5).
(39) Install damper sleevein offsetlever.
(40) Coat backup lamp switch threads with RTV
sealant, or equivalent, and install switch in case.
SPECIFICATIONS
Transmission Specifications Model T4
Lubrication
Level to bottom of ffli hole
InspectCorrectFill Levels 5,000mi/5 mo/8000 km initially,
then every 7,500 mi/7% mo/12 000 km thereafter
Recommended Lubricants AMC/Jeep Automatic Transmission
Rutd or equivalent labeled Dexron ll«
Lubricant Capacity
U.S. Measure 3.5 pints
Imperial Measure 2.9 pints
Metric Measure 1.7 liters
60790
Torque Specifications Model T4
Service Set-To Torques should be used when assembling eomponents. Service In-Use Recheck Torques should be used for checking a pre-tlghtened hem.
USA Ift-lbs) Metric (N-m)
Service
Set-To
Torque
Backup Lamp Switch 15
Adapter Housing Bolt 13
RllPlug 20
Ront Bearing Cap Bolt 13
Reverse Lever Pivot Bolt 20
Shift Control Housing Bolt 10
Transmission Cover Bolt 7
Transmission-to-Cfutch Housing Bolt 55
UniversalJoint Clamp Strap Bolt 14
AD Torque values given in foot-pounds and newton meters with dry fits unless otherwise specified.
Service
Service
In-Use Service
In-Use
Recheck Set-To Recheck
Torque Torque
Torque
12-18 20
16-24
11-15
18 15-20
15-25 27
20-34
11-15
18 15-20
15-25
27 20-34
7-12
14 9-16
5-9 10 7-12
45-65
75 61-65
12-18
19 16-24
60791
MODEL T5 5-SPEED
TRANSMISSION
Owning and Inspection
Specifications
Pige
2B-23
2B-26
TRANSMISSION DISASSEMBLY
CAUTION: Except for the gearshift lever attaching
bolts and fill plug, all threaded holes and bolts used in
the Model T5 Transmission case have metric threads. If
replacement bolts are required during service, use only
Transmission Assembly
Transmission Disassembly
Page
2B-24
2B-18
those of the same size and length as the originals.
(1) Remove drain bolt on transmisson case and
drain lubricant (fig. 2B-39).
(2) Using pin punch and hammer, remove roll pin
attaching offset lever to shift rail (fig. 2B-5).