Lighting Systems - Jeep J-10 Series 1982 Technical & Service Manual

P
LIGHTING
SYSTEMS
Chassis Wiring Harness
Exterior Lighting Systems
SECTION INDEX
Page
3R-13
3R-1
Interior Lighting Systems
Tools
3R-1
Page
3R-11
3R-17
EXTERIOR LIGHTING
SYSTEMS
GENERAL
The wiring of the lighting systems is shown in the
wiring diagrams which indicate the various units in
relation to their positions in the vehicle. The wires in the
various circuits are different colors or are marked by
tracers.
All models have a 24-amp circuit breaker built into
the switch for light system protection.
The upper and lower headlamp beams are controlled
by a foot switch located on the toeboard.
HEADLAMPS
All models are equipped with a single headlamp
system.
The round headlamp used with the CJ and Scrambler
system is identified by the number 2D1 embossed on the
sealed beam face. The large rectangular headlamp sys
tem is used on all Cherokee, Wagoneer and Truck mod
els. All lamps contain two elements: one low beam and
one high beam.
Backup Lamps and Switches
Cargo Lamp
DIractlonal Signal Switch
Engine Compartment Lamp
Fog Lamps
General
Page
3R-5
3R-6
3R-6
3R-11
3R-9
3R-1
Headlamps
License Plata Lamp
Parking. Side Marker, and DIractlonal Lamps
Rear DIractlonal. Side Marker. Stop and Taillamps
Stoplamp Switch
4-Way Emergency Rasher (Hazard Warning)
Page
3R-1
3R-5
3R-3
3R-3
3R-9
3R-9
CJ and Scrambler Models
Replacement
NOTE: CJ and Scrambler headlamps have a number
2Dl molded into the glass at the top of the lens.
(1) Remove attaching screw and pull door out
slightly at bottom and push up to disengage upper re
taining tab.
(2) Loosen screws in retaining ring, rotate ring to
disengage from screws.
(3) Pull headlamp out and disconnect wire harness.
(4) Install replacement headlamp with number 2D1
at TOP of lamp.
(5) Install retaining ring and tighten screws.
(6) Install headlamp door and attaching screw.
(7) Check headlamp aim following procedure out
lined below.
Cherokee-Wagoneer-Truck Models
(1) Remove headlamp door, if equipped.
(2) Remove screws attaching retaining ring and re
move ring.
(3) Pull headlamp out and disconnect wire harness.
(4) Install replacement headlamp and connect to
wire harness.
(5) Install retaining ring and attaching screws.
Each sealed beam headlamp can be replaced only as a
complete unit.
I