Jeep J-10 Series 1982 Technical & Service Manual page 1125

HARDTOP ENCLOSURE-SUN ROOF AND LU66A6E RACKS 3L-7
allow several minutes for penetration. Apply a second
application and allow several minutes for the adhesive
bond to soften. Use a wooden wand or fiber stick to pry
the weatherseal from sun roof glass frame. Clean weath
erseal and adhesive residue from the frame channel
with 3M General Purpose Adhesive Cleaner, or
equivalent.
To install the replacement weatherseal, first apply a
thin bead of 3M Super Weatherseal Adhesive, or equiva
lent, to the glass frame locating channel. Using wooden
wand or fiber stick, install weatherseal in sun roof glass
frame. Apply a thin film of petroleum jelly on seal-to-
glass contact surface.
CHER0KEE-WA60NEER
A manually operated sun roof (fig. 3L-10) is available
for Cherokee and Wagoneer models. The sun roof can be
opened and locked in place or removed entirely. To re
move the sun roof glass, compress the latch arms at the
frame bracket and disconnect the latch from the frame.
Tilt the glass to an angle greater than 60 degrees, release
the bayonets from the retainers and remove the glass.
Safely stow the glass in storage compartment.
© BAYONET
COVER
CLAMP \ — 901 SOB
Rg. 3L-10 Sun Root Components—Clterokoe-Wigonitr Models
Glass Frame Weatherseal
Removal
(1) Remove glass assembly.
(2) Apply 3M Release Agent, or equivalent, to
weatherseal and allow several minutes for penetration.
(3) Apply second application and allow several min
utes for adhesive bond to soften.
(4) Remove seal from frame.
(5) Remove all residue from frame with 3M General
Purpose Adhesive Remover, or equivalent.
Installation
(1) Apply thin bead of 3M Super Weatherstrip Ad
hesive, or equivalent, in channel.
(2) Install weatherseal in channel.
(3) Apply thin film of petroleum jelly on seal-to-
glass contact surfaces.
(4) Install glass assembly.
Frame
Removal
(1) Remove frame cover (fig. 3L-10).
(2) Remove headliner as described in Chapter 3P.
(3) Remove sun roof glass.
(4) Remove frame attaching screws and clamps.
(5) Remove frame assembly.
Installation
(1) Clean sun roof frame and roof panel contact
surfaces using 3M General Purpose Adhesive Cleaner
and Wax Remover, or equivalent.
(2) Apply bead of 3M Clear Super Silicone Sealer, or
equivalent, on surface of outer roof panel, 1/8 inch from
edge of opening.
(3) Install sun roof frame in roof panel.
CAUTION: Do not install retainers on roof panel in
dentations. Tighten attaching screws in a criss-cross
pattern.
(4) Install sun roof clamps and attaching screw.
Tighten to 7 to 9 inch-pounds (0.79 to 1.02 N»m) torque.
(5) Wipe excessive sealer from roof panel.
(6) Install sun roof glass.
NOTE: Check sun rooffor waterleaks.
(7) Install headliner as described in Chapter 3P.
(8) Install frame cover.