Specifications - Jeep J-10 Series 1982 Technical & Service Manual

r
m
MANUAL STEERING GEAR 2K-11
SPECIFICATIONS
Manual Steering Gear Specifications
Gear-Type Recirculating Ball
Ratio 24:1
Bearings
Upper Ball
Lower Ball
Adjustments:
Worm Bearing Preload 8 in-lbs.
(0.90 N-m)
Pitman Shaft Overcenter
Drag Torque 4-10 in-lbs.
(0.45-1.13 N-m) in addition to
8 in-lbs. (0.90 N-m) worm
bearing preload for a total of
16 in-lbs. (1.8 N.m) maximum
Adjuster Screw End Play 0.002 in. (0.05 mm)
80435A
Torque Specifications
Service Set-To Torques should be used when assembling components. Service In-Use Recheck Torques should be used for checkings pro-tightened Item.
USA (ft-lbs) Metric (N-m)
Service
Set-To
Torque
Intermediate Shaft Coupling Clamp Bolt 45
Pitman Arm Nut 185
Steering Gear Mounting Bracket-to-Gear Bolts (CJ) 70
Steering Gear Mounting Bracket-toTie Plate Bolt (CJ) 55
Steering Gear Mounting Bolts (Cke., Wag., Trk.,) 70
Side Cover Bolts 30
Adjuster Screw Locknut 23
Worm Bearing Adjuster Locknut 90
All torque values given in foot-pounds and newton-meters with dry fits unless otherwise specified.
Tools
Service
Service
In-Use Service In-Use
Recheck Set-To
Recheck
Torque Torque Torque
40-50 61 54-68
160-210
251
217-285
60-80
95 81-108
50-60 75
68-81
60-80
95
81-108
25-35 41 34-47
18-27 31 24-37
70-110
122
95-149
60704
^aea.
BEARING CUP
INSTALLER
J-5755
-
# I
h m I
-
r0""'
BEARING CUP
PULLER
J-5822
TORQUE WRENCH
J-7754
J-6632
PITMAN ARM
PULLER
SLIDE HAMMER
J-2619-01
80439